Connecting a Laptop to a Sharp AQUOS Board (Sharpboard)

  • If you are connecting a laptop to the Sharpboard, you will need to change the input to VGA and use the VGA cable to connect.
  • If this screen is not seen the input on the Sharp should probably be changed to the HDMI setting.  This can be done by using the small remote usually located inside the front tray of the Sharp or by manually pressing the input button located on the bottom right of the front face of the Sharp. 

  • Once the Dell has completed its boot then the NCCU log-in screen should be visible.  Log-in as you normally would by using the available wireless keyboard and mouse to fill in your username and password in the appropriate fields.

 

Was this helpful?
0 reviews

Details

Article ID: 130530
Created
Wed 3/17/21 3:29 PM
Modified
Sat 7/8/23 8:14 AM